Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
75792
1.INSTALL DOOR WINDOW FRAME MOULDING CLIP
Attach the 2 claws to install the door window frame moulding clip.
75756C
2.INSTALL FRONT DOOR WINDOW REAR FRAME MOULDING LH
When installing the window frame moulding, heat the front door panel and window frame moulding using a heatlight.
| Item | Temperature |
|---|---|
| Front Door Panel | 40 to 60°C (104 to 140°F) |
| Window Frame Moulding | 20 to 30°C (68 to 86°F) |
Do not heat the front door panel and window frame moulding excessively.
Clean the front door panel surface.
Using a heat light, heat the front door panel surface.
Remove the double-sided tape from the front door panel surface.
Wipe off any tape adhesive residue with cleaner.
Install a new front door window rear frame moulding LH.
Using a heat light, heat a new front door window rear frame moulding LH and the front door panel surface.
Remove the peeling paper from the face of the front door window rear frame moulding LH.
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
| *1 | Protective Tape |
| *2 | Double-sided Tape |
Attach the clip and double-sided tape to install the front door window rear frame moulding LH.
Press the front door window rear frame moulding LH firmly to install it.
67862
3.INSTALL FRONT DOOR WEATHERSTRIP LH
Install the front door weatherstrip LH.
75720
4.INSTALL FRONT DOOR BELT MOULDING ASSEMBLY LH
68151D
5.INSTALL FRONT DOOR GLASS RUN LH
68102
6.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH
67832
7.INSTALL FRONT DOOR SERVICE HOLE COVER LH
87940
8.INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH
67602
9.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
69284C
10.INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
74642A
11.INSTALL FRONT DOOR ASSIST GRIP COVER LH
12.INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL
67492A
13.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH
14.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
15.CHECK POWER WINDOW CONTROL SYSTEM
w/o Jam Prptection Function:
16.CHECK OUTER REAR VIEW MIRROR